shiphteey

Needs a job
Posts: 2529
|
posted May 06, 2007 11:06 PM
Back from the 1/4 mile after 20 months!
Brief history:
Bought the bike and ran it June 05...
10.2 @ 141-142 bone stock twice....
Threw on a 40 shot, pipe, filter, pc3r tuned safe, pump gas, lowered:
10.1...10.0.....then a 9.81 @ 148....spraying in 3rd and all of 4th Stock gearing had me pissing in the wind....
Did some LSR from then till now and frequented the 1/8 mile strip running 6.8 bone stock. In its altered form I was w/gearing changes here and there I ran 6.3-6.5 depending on gearing (always coming thru right about 118)...
Broke a 1.6 60 ft finally mid-late 06?
Still kept at it...chipping away.....wheelies at the end of 1st....you know the drill but managed low 1.7s average....a couple 1.6s every time I'd go to the 1/8 mile:
Fast forward to today. With carbon fiber wheels, a fiberglass step seat (that I taped towels to so I wouldn't still slide 2 inches and invoke more wheelies ), swapped stainless header for titanium, lighter rear rotor, ceramic bearings, stiffer valve springs, even lower ride height, gearing set at -1 up front and - in the rear (hey a lil more wheelbase and grunt is good! )
Get to MIR...headwinds 1st run I go out naturally aspirated:
60 ft 1.716
1/8: 6.5 @ 117.16 (slower extrema of what I usually run )
1/4: 9.881 @ 148.17
That is about the same MPH and ET that I ran in 05 with stock gearing spraying 3rd and 4th
Decide to mount the bottle and get to work....
60 ft 1.675 (cha ching!)
1/8: 6.625 @ 116.72 (BIG WHEELIE )
1/4: 9.953 @ 147.96
How do I explan to the avg joe that I went SLOWER on spray than n/a Just goes to show if you mess up your run early on even spraying still just ain't enough most of the time....in this case the spray just helped "make up the difference" ... almost.
Warm up the bottle a little more....but not much as the battery was dying from not being started (which I wanted to avoid because then the motor would be too hot )
60 ft 1.706
1/8: 6.468 @ 122.06 (2 mph faster than I have ever gone in the 1/8 spraying 2nd no wheelie in 2nd)
1/4: 9.663 @ 154.07 !!!!!!!!!
Needless to say I'm stoked. I figured at best I'd do mid 9s @ 154 and I was right there so I was happy. Now enjoying the runs, lighthearted, just out there to have fun. Spray again but bottle psi is around 850-900...
60 ft 1.691
1/8: 6.297 @ 123.67 PERSONAL BEST!
1/4: 9.461 @ 155.49
WOOHOOOOOOOOOOOOOOO!!!!!! Felt really good about that run. Felt like a 9.7 to be honest! Spray from 2nd thru 4th felt soft, like a 30 shot to be honest because I started that day with the bottle about 80% full....plus a bit colder/lower psi than optimal
Last run of the day, found the resident drag racer there who is ALWAYS there when I am there (and I'm not there much anymore)....he rocks a zx12 but now jumps on everyone's bike as a jockey....a few pounds heavier than I but more skilled). Asked him how to launch the 12 (I launch 5-5.5k) He said 3k! I knew I'd bog but he said do it and go WOT asap!! I said fack it, I'll try it....
Well didn't work out....bogged it.....still sprayed it in 2nd..no wheelies.....
9.7 @ 155 (can't find the slip).....
Still inconsistent....still kinda quick/fast.....still having fun! Guess its time to update the sig again, eh?
A.
|
zx12dak
Expert Class
Posts: 103
|
posted May 07, 2007 01:56 AM
Nice report Ship! Good job getting into the 9.40's!
|
DahMurf

Expert Class
2006 Hayabusa - Black
Posts: 132
|
posted May 07, 2007 05:23 AM
Nice report but you left out one detail! Admit it, you did so well on your fourth run cause you were afraid of being beat by that chick on the Busa! (ok, maybe afraid to be accidentally run over by and launched fast to get away from her) but hey, I'm sticking to my story! I caught you at the end! (end of shut down! hehehe)
Some day I'll get you, all I need is practice!
It was a great run & looked good from my vantage point and we have proof that I was there!
Deb
____________
Miss you my friend - #1302 Twin Jugs Racing
ECTA 200 MPH club@202 / Texas 200 MPH club@209 / Loring 200 MPH club@218
|
g_right

Novice Class
Posts: 84
|
posted May 07, 2007 05:57 AM
Good post shiphteey, wish I could have stayed longer...but it was hard not to be on the track with you guys, and Litt Dave got tired too. I should have my fuel pump Friday and be back in the the race.
Look out Deb is going to be on your back tire next time....
|
DahMurf

Expert Class
2006 Hayabusa - Black
Posts: 132
|
posted May 07, 2007 07:43 AM
Dave,
Great to see you again! I'm in love with little Dave, he is the sweetest! The highlight of my day was watching him pull mega wheelies when he thought no one was watching & seeing him do laps around the truck! I was about ready to start timing him! He was really getting on it! He's just a ball of fun with a great attitude and that need for speed! Let me know when you build that drag chair for him, I want to be one of his sponsor! He rocks!
Deb
____________
Miss you my friend - #1302 Twin Jugs Racing
ECTA 200 MPH club@202 / Texas 200 MPH club@209 / Loring 200 MPH club@218
|
shiphteey

Needs a job
Posts: 2529
|
posted May 07, 2007 07:53 AM
Haha, I remember those wheelies. Good meeting you Dave, saving my motor and clutch for a land speed race this May and grudge June 1 MIR so I'll skip out on the rest of T&T till then unless I bring the 6 for kicks.
Deb, thanks for having me over theother night, I appreciate the hospitality....and the soap, water and WD40 were good for a tenth given the state of my bike, lol!
You're gonna have to pull something outta your ass now that your man beat you on the 1k! Props for him running 10.2s back to back.
A.
|
DahMurf

Expert Class
2006 Hayabusa - Black
Posts: 132
|
posted May 07, 2007 08:15 AM
True true, the shifter got him over the top but I've still out MPH'd him and right now that's where it's at for me. I didn't have one clean run all day so time will tell what I can do. My main focus right now is May at Maxton. The results of that meet will dictate which way we go for June. After all that we may spend the summer hitting the 1/8 miles to work on our reaction times for Drag. Still out of 8 runs on the drag strip I'm not doing bad. Once I can get a system & pull it all together consistantly we'll just see who I'm chasin down. LSR next who's getting top speed?
No problem on the soap & such! Any time we can assist in getting you to clean up your act we're happy to do so!
Deb
____________
Miss you my friend - #1302 Twin Jugs Racing
ECTA 200 MPH club@202 / Texas 200 MPH club@209 / Loring 200 MPH club@218
|
narider

Expert Class
Posts: 246
|
posted May 09, 2007 09:31 AM
9.4 kicked ass, but 155mph was way cool though!!!! What a great weekend.
Thanks for all the tips.. you've got that 12 humming man.
Todd
PS: anyone know if there's a way to edit posts after you've already posted, like days later, etc.?
|
rac4it

Needs a job
Bergie
Posts: 3009
|
posted May 10, 2007 01:13 PM
Your bike will run 9.5s stock wheelbase without nitrous. Take the bottle off until you get there, then put it back on and see what happens!!
|
|
|