HOME ARTICLES JOIN GALLERY STORE SPONSORS MARKETPLACE CONTACT US  
Register | FAQ | Search | Memberlist
Username:    Password:       Forgot your password?
BIKELAND > FORUMS > ZX-14.com > Thread: valve cover gasket washers NEW TOPIC NEW POLL POST REPLY
06redzx14


Pro
Posts: 1022
 		posted December 01, 2009 12:40 PM        
valve cover gasket washers

what size washer? M10 or M6?
____________
06 alien head, no flies, PC+hub, 16/45 44 43, air shifter, dry shot
  Ignore this member   
1badzx12r


Needs a life
Posts: 8321
 		posted December 01, 2009 02:09 PM        Edited By: 1badzx12r on 1 Dec 2009 22:11
i guess its the m10 .. you want the washers to go over the shoulder on the bolt ..




and get the thinnest washer you can get ...cause if you tighten the bolts to tight it squishes the plug gaskets ...and makes it hard to get the plug tool on the plugs later..
____________
http://www.youtube.com/watch?v=S06nIz4scvI
  Ignore this member   
3000psi and falling


Zone Head
Posts: 848
 		posted December 01, 2009 04:26 PM        
Sorry i posted m6, m10 is correct. Torque is 9.8Nm or 87 inch/lbs for the cam cover.
____________
08 ZX14, 2010 Persimmon Red bodywork.
Flies pulled, 16-42, BMC street, 8" extensions, drag shock, cut pan, Cycle Concepts Drag Pack and springs, muzzy m14 w/ oval can, lowered, Shinco usoft rear, pcv with autotune, leightweight Shori 18ah battery, throttle meister. 500lbs at bandimeres scales with half tank of juice.
  Ignore this member   
All times are America/Va < Previous Thread     Next Thread >
BIKELAND > FORUMS > ZX-14.com > Thread: valve cover gasket washers NEW TOPIC NEW POLL POST REPLY

FEATURED NEWS   Bikeland News RSS Feed

HEADLINES   Bikeland News RSS Feed

Copyright 2000-2026 Bikeland Media
Please refer to our terms of service for further information
0.33758306503296 seconds processing time