Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 06:35 AM
quote:
finally! someone that watches the 330 times.
What, you haven't been reading my posts? 
  
|
Wheelie
Needs a life
Old Man
Posts: 6902
|
posted October 11, 2009 06:38 AM
quote:
quote:
finally! someone that watches the 330 times.
What, you haven't been reading my posts?
Ive been using the ignore button on you hehehe
wee
|
kawasakijockey
Pro
Posts: 1876
|
posted October 11, 2009 06:49 AM
Looking at the times there, there is something not right between the 330 and 1/8 because your et is only 6.01 to 6.05. I am comparing your runs to mine last night and you should have at least run 5.95 or lower. I was running 1.49 60's with 3.98-3.99 330's and doing 6.01's. If it isnt tire pressure it is either spinning the tire at a shift or pushing through the clutch a little. A sign of a clutch going away is when you run 60's and 330's you could not before but the et falls off. Were you hot lapping?
____________
Get on the shortbus boys 'cause its time to get schooled.
2007 ZX-14
1.38 60ft
9.03 @ 149mph
8.95 @153 small shot n2o
8.68 @160mph 5lbs boost
|
Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 06:54 AM
 Edited By: Shane661 on 11 Oct 2009 14:57
Another slip, from last year, for comparison (#44):
Equal to your 1/8th...with a .08 slower 60 foot. That was with 16/45 gearing and I couldn't get in the throttle quick at 63". That was back when my bike and I were heavier as well. And, to honest, I wasn't riding the bike very well.
Shane
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 11, 2009 06:59 AM
Yes I was kinda hot lapping, ab every 20 min because I got there late and wanted to get as many passes in as possible. I think I got 7 passes, first one blew the tire off, last one busted the pan. I had a buddy holding onto the timeslips, and he lost 2...
Shane can we really compare times with your bike being so much lighter? I guess I'm asking can I actually compare the times?
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 06:59 AM
Edited By: Shane661 on 11 Oct 2009 15:00
quote:
Shane can we really compare times with your bike being so much lighter? I guess I'm asking can I actually compare the times?
That slip was from when my bike was set up like yours...but shorter. And I was heavier than you at the time, and on pump fuel.
|
Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 07:03 AM
Edited By: Shane661 on 11 Oct 2009 15:03
quote:
Yes I was kinda hot lapping, ab every 20 min because I got there late and wanted to get as many passes in as possible.
One pass every 20 minutes is easy on the bike. I will often do 3 within 10-12 minutes at the track rental days. With as much gear as you have, you shouldn't have to slip the clutch much.
Shane
|
kawasakijockey
Pro
Posts: 1876
|
posted October 11, 2009 07:05 AM
quote:
Yes I was kinda hot lapping, ab every 20 min because I got there late and wanted to get as many passes in as possible. I think I got 7 passes, first one blew the tire off, last one busted the pan. I had a buddy holding onto the timeslips, and he lost 2...
Shane can we really compare times with your bike being so much lighter? I guess I'm asking can I actually compare the times?
I am 10 lbs heavier than you with 16/42 gearing for reference too. Full tank of fuel too.
____________
Get on the shortbus boys 'cause its time to get schooled.
2007 ZX-14
1.38 60ft
9.03 @ 149mph
8.95 @153 small shot n2o
8.68 @160mph 5lbs boost
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 11, 2009 08:29 AM
Now that I have the pc on there I might try and see if the asart rear works again. What u launch at kawasakijocky? I launched at 5k with the 48 rear and 7k with the 43t
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
kawasakijockey
Pro
Posts: 1876
|
posted October 11, 2009 09:11 AM
Low fuel level 4000rpm. Full tank 6000rpm.
____________
Get on the shortbus boys 'cause its time to get schooled.
2007 ZX-14
1.38 60ft
9.03 @ 149mph
8.95 @153 small shot n2o
8.68 @160mph 5lbs boost
|
Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 03:18 PM
Edited By: Shane661 on 11 Oct 2009 23:39
I'm going to guess you are sitting at around 65". Just out of curiosity, what rpm on the tach do you shift?
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 11, 2009 03:22 PM
On tach 11000. Shift light set at 10900
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 03:39 PM
You're a heavier guy and you might see better results by shifting at about 11300 indicated.
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 11, 2009 04:36 PM
Will change shift light when I get it back running. "Short shifting" those 400 rpms could take some off the time I suppose.
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
Shane661
Needs a life
Posts: 11494
|
posted October 11, 2009 04:43 PM
Edited By: Shane661 on 12 Oct 2009 00:51
You can set the light for 11200 indicated, and you should be safe. 
Assuming this is the factory shift light. If it is an MSD or similar, you would need to set it for the true rpm you wish to shift at.
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 11, 2009 05:17 PM
Yes fact shift light. Thanks for helpful info!
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 13, 2009 07:40 AM
I plan on getting a msd shift light soon.
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
Shane661
Needs a life
Posts: 11494
|
posted October 13, 2009 07:40 AM
I have one sitting on my desk; keep an eye out in the classifieds.
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 13, 2009 07:50 AM
if you dont get rid of it by the time i get a little bit of extra cash, ill shoot ya a email
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
Shane661
Needs a life
Posts: 11494
|
posted October 13, 2009 07:51 AM
10-4
|
2000redrocket
Pro
Posts: 1662
|
posted October 17, 2009 09:48 AM
what a great 60ft. i agree that that 60ft does not go with the 330 or 1/8mile. my best 1/8 sofar has been 6.09 @119.27 clean shifting the bike and had i been in the low1.4s like you i would run a low 9.1x in the 1/4. i will not be able to get that low of a 60 i am betting . try grabbing higher on the throttle at launch. it will equate to more power sooner than before if you do not grab high already. it helped me.
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 17, 2009 09:59 AM
I'm going to run it one more time where the gearing is now, add the rest of the links in the chain, and it still dosent pull decent times I'm going to put my stock 17t sprocket on the front and see what that does. 17/48 would be close to 16/45, right?
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 17, 2009 10:02 AM
quote:
looks good, get the seat painted.
I forgot to tell you I did paint it after the crash. I didn't have any silver rattle cans so I used some good gloss black, and it looked good until I ran out and got overspray on it.
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 17, 2009 05:47 PM
Just thought I'd add this. This is my best pass on my 06 zx14..
60. 1.462
330. 3.849
1/8. 5.850
Mph 121.15
1000. 7.627
1/4. 9.150
Mph. 147.31
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
eklipse636
Needs a life
ZX-14
Posts: 6046
|
posted October 17, 2009 05:52 PM
My last question on this thread was approx how much time do you lose when you drag your feet. I catch myself at times not pulling my feet up until mid/high 2nd gear. I also see guys leave em hanging the whole pass, which is unnecessary. Just curious.
____________
Best: 60ft 1.351 1/8 5.68 mph 123.98 1/4
8.89 mph 151.32
|
|
|
HOME
NEW TOPIC