dubious

Needs a life
Needs more time to ride!
Posts: 8442
|
posted July 08, 2009 12:49 PM
Yes, I know, they are not corner carvers LOL
____________
natural selection.....
destiny will overcome intervention.
Some are not worthy of the effort.
|
Shane661

Needs a life
Posts: 11494
|
posted July 08, 2009 04:07 PM
Edited By: Shane661 on 9 Jul 2009 00:15
Lyle, why is the compression so high on the MTC pistons? 10.5:1?
So you ended up going with secondary injection instead of the large injectors?
|
dubious

Needs a life
Needs more time to ride!
Posts: 8442
|
posted July 08, 2009 05:03 PM
yes secondaries, for drivability, tunability, and reliablity.
I now have 100 lbs per cylinder, and 1:1 regulator.
They actually end up at 9.2:1 with my .050" head gasket.
Not sure exaclty why 10.5:1, except the domes are mega thick, and there is no clearance problems under the piston, between the small end of the rod and under the dome.
The JE have been known to be tight, especially on the (other) stock rod length 9.5:1 turbo piston,
I had to have the pin bores on the JE's honed, Cold, I couldn't push 2 of them in by hand, maybe .001 clearance.... engine machinist was not impressed, once everything tightend up with heat, could be disastrous.
____________
natural selection.....
destiny will overcome intervention.
Some are not worthy of the effort.
|
Compton

Zone Head
Posts: 969
|
posted July 14, 2009 06:51 PM
any pictures of the jones injection system?
____________
b.w.
zx14, little longer, little louder, little lower.
08 Busa, just a little longer and louder and lower than the 14
|
|
|