BA
Pro
Posts: 1592
|
posted March 29, 2003 09:51 PM
ATTN:......... RA12R
Hey dude,.....I just wanted to tell you THANKS for some posts you had in an older thread about 12R shift forks, and people missing shifts, false neutrals, etc.
It was because of your knowledgeable posts in that thread, and your good description, that I "tackled" this job of replacing shift forks when I've never been inside a motorcycle engine before.
It's not back together yet (knock, knock), but getting it apart to replace those shift forks was CAKE. Who needs a fookin' manual?
I should have done this last August.
Thanks again man.
THANKS ALSO TO MADMIKE for his phone support & direction!!! 
Allan
  
|
ra12r
Zone Head
Posts: 919
|
posted March 30, 2003 05:35 PM
BA, I can honestly say that you truly made me smile!!! You are more than welcome for the info shared. I too have recieve much info from SOME board members that have really helped me in the real world. I am sure that you have save yourself a TON of money and feel good about the accomplishment. The change is not for everyone to tackle, but the problem is not the "drama issues" that these bike builders exaggerate to over charge people!!! NO ZX12R needs undercut gears!!! The problem you had EVERYONE will eventually have to address!!!! BA, I am sure you see and understand why it is unavoidable. Be blessed and enjoy!!!
____________
All must bow to the "Ra Supremecy"...
|
kcadby
Pro
Posts: 1733
|
posted April 01, 2003 10:02 AM
I'm replacing one fork on the motor that I'm building right now... 
|
|
|
|
|
HOME
NEW TOPIC