NINJA12
Needs a job
Posts: 3310
|
posted February 23, 2009 03:02 PM
Who can resize rods
I think I remember Jim (Y2K).
Anyone have contact information for him?
Any other recommended places?
  
|
KZScott
Needs a life
high on speed
Posts: 7235
|
posted February 23, 2009 03:12 PM
Jim is getting mine when i send him my head(if he wants the buisness  )
competitioncnc.com
____________
01 ZX-12R 8.84 @ 156.3 no bars, DOT tires. Pump Gas, NA.... turbo 8.47 @ 164.
00 ZX-12R 8.62 @ 165.2 no bars, slicks, Pump Gas, 55 shot.... turbo 8.32 @173
00 ZX-12R Fastest NA Kawasaki in the world 1: 222.046 1.5: 226.390 Loring AFB
00 ZX-12R street turbo 1: 227.9 1.5: 234.1 Loring AFB
00 ZX-12R LSR turbo 1: 263.1 1.5: 266.5 Loring AFB Worlds fastest ZX-12R
CMG Racing RCC Turbos
|
osti33
Needs a job
Posts: 2973
|
posted February 23, 2009 03:20 PM
I always send mine to Jim. He has done a few sets of Carrillo's for me and I know a few sets for Karl as well.
860-274-0631
That is the shop phone number.
|
ninja12
Needs a job
Posts: 3310
|
posted February 23, 2009 07:14 PM
Thanks,
What's the cost for a set?
|
Y2KZX12R
Needs a job
CompetitionCNC.com
Posts: 3762
|
posted February 23, 2009 07:45 PM
Yea we can resize them for you. I think its $125... I'll have to look tomorrow for you.
We will need your rod journal sizes and a new set of rod bearings sent with the rods.
____________
Y2KZX12R
CompetitionCNC.com
|
NINJA12
Needs a job
Posts: 3310
|
posted February 25, 2009 09:41 AM
New bearings ordered,
Rods on the way as soon as they get here.
Thanks everyone,
|
Y2KZX12R
Needs a job
CompetitionCNC.com
Posts: 3762
|
posted February 26, 2009 04:47 AM
Ok, we'll get them fixed up for ya. The one that got hot... did the bearing spin?
____________
Y2KZX12R
CompetitionCNC.com
|
NINJA12
Needs a job
Posts: 3310
|
posted February 26, 2009 12:56 PM
no, very little gold .
Probably did most of the damage looking for the knock.
|
Y2KZX12R
Needs a job
CompetitionCNC.com
Posts: 3762
|
posted February 27, 2009 08:18 AM
ok, doesnt sound too bad.
____________
Y2KZX12R
CompetitionCNC.com
|
NINJA12
Needs a job
Posts: 3310
|
posted March 03, 2009 06:22 AM
Everything is boxed and ready!
Finally got the new bearing in and measurements done.
Should be going out today.
For those who have never done this.
You have to send rods, new bearings, and actual journal size.
That means measured not the range given in the book.
|
|
|
HOME
NEW TOPIC