posted September 23, 2002 06:44 AM
Can't find neutral?? Just got my 02 ZX12R, can't hit neutral unless I am at a complete stop. I have never had this prob on the other bikes, usually I can hit get there during a rolling stop.
Is this normal, did they do this for some 'safety' reason. It is rather annoying.
posted September 23, 2002 08:04 AM
I go down into 1st then toe it up to neutral. Seems to work fine
____________
This moderator uses moderation in moderation
posted November 18, 2002 02:34 PM
Not one of my favorite Kawasaki ideas.
____________
To those who do not count their life in years, but in how life
has touched them in the past and how much it can hold in the
future; -- Youth is forever.
posted November 18, 2002 02:55 PM
I had the same problem about not being able to get to neutral until I was at a full stop. I eventually got used to the light tap that is necessary to find it while moving.
Give it a couple weeks. YOu'll get it.
____________
-----------
"There are only three sports: bullfighting, motor racing, and mountaineering; the rest are just games." - Ernest Hemingway
posted November 18, 2002 03:15 PM
Then I don't know what to tell you. I've only had mine since June, and I have no problem finding neutral on the roll.
____________
-----------
"There are only three sports: bullfighting, motor racing, and mountaineering; the rest are just games." - Ernest Hemingway
posted November 18, 2002 03:26 PM
Ive noticed people who run alot of play in there clutch lever have more problems getting to neutral. You might try adjusting the free play in your lever in & out to see if it helps.
posted November 18, 2002 10:16 PM
It is nice to coast up to a red light, kick it into neutral prior to coming to a stop. I have done it for years. Especially helpful on the freeway in stop and go stuff. Unless you have popeye forearms!
____________
To those who do not count their life in years, but in how life
has touched them in the past and how much it can hold in the
future; -- Youth is forever.