johnnnyboy
Expert Class
08 Concours 14
Posts: 164
|
posted September 08, 2008 10:35 AM
need some help with troubleshooting
well I washed the bike as usuall and was carefull not to flood every thing. I planed a drive around the trail and for some reason the bike would start for a few seconds then die. I cranked it over and it will rev to 4k for a few sec then die any ways after 10 min it worked its way out and we went for our ride. 40 min into the drive same thing but this time left me standed. The bike is getting plenty of fuel its like as soon as it starts reving to 4- 8 k then just like putting kill switch on . Cuts out imediatly. There wasnt much we could do on the side of the road with no tools but i did take the seat off and the conector to the rectifier was full of oil. Dumped all that out and I disconected the neutral saftey switch but still nothing . Of course at this time the battery was dead.
Any thoughs on where to start or similar problem before I rip her apart ?
thanks 2000 zx12
  
|
CrotchRocket
Moderator
Bracket Racing with Betsy
Posts: 8038
|
posted September 08, 2008 02:54 PM
How old is the battery???
Whats the condition of the gas cap rubber seal???
Check all the wire connections
____________
Jason Miller StreetBike Seminars
*****DragRacers do it better, because they dont cut Corners*****
|
johnnnyboy
Expert Class
08 Concours 14
Posts: 164
|
posted September 09, 2008 04:47 AM
well i diconected the power comander andevery thing is fine I reconect it and reloaded the map still no good. So whats the deal, power commander is toast ? has any one had a similar problem with the PC 3 ? the wiring on it has no nicks or cuts
|
johnnnyboy
Expert Class
08 Concours 14
Posts: 164
|
posted September 09, 2008 04:48 AM
I should have said that after i disconected the PC thebikeworked fine
|
|
|
HOME
NEW TOPIC