HOME ARTICLES JOIN GALLERY STORE SPONSORS MARKETPLACE CONTACT US  
Register | FAQ | Search | Memberlist
Username:    Password:       Forgot your password?
BIKELAND > FORUMS > ZX12R ZONE.com > Thread: Checking Oil Level ?????? NEW TOPIC NEW POLL POST REPLY
zx12rpilot


Expert Class
Posts: 120
posted July 03, 2002 08:46 PM        
Checking Oil Level ??????

Any ideas or does everyone have stands? Hard to see sight glass and hold bike at the same time... Suggestions?
Don't mind getting stands but somebody tell me where.....

  Ignore this member   
swft


Needs a life
Full throttle!
Posts: One MEEEEEELLION
posted July 03, 2002 09:28 PM        
http://www.pit-bull.com/

When you care to buy the very best...

  Ignore this member   
fast


Novice Class
Posts: 40
posted July 03, 2002 11:53 PM        
Me i strap the bike on the trailer put the level
on the side of the rear tire, cant be more strait
than that!At 2.8 liter the glass was only fill
at 1/3 !!!So to the top mark your way to mutch!
____________
9.29@151

  Ignore this member   
12RPilot


Pro
Posts: 1094
posted July 04, 2002 04:28 AM        
I have a "calibrated" piece of wood that I put under the kickstand that keeps the bike vertical. Of course, you need to keep pressure against the bike in the direction of the kickstand but it's handy for a quick level check.
____________
If you aren't an AMA member, you're part of the problem.
NESBA #209

http://www.bikepics.com/members/12rpilot/04zx10r/

  Ignore this member    Click here to send 12RPilot an ICQ message. Click here to add 1781480 to your ICQ list. 
phil


Expert Class
Posts: 420
posted July 04, 2002 06:36 AM        
I just sit on the bike holding it level and use a telescoping mirror.
  Ignore this member   
Wildman


Expert Class
I only look confused
Posts: 318
posted July 04, 2002 07:16 AM        
I use the Pit Bull stand, and I can't say enough about how great it is.
But, to do it without a stand isn't that hard (just kinda scary). Hold the right grip and squeeze the front brake. crouch down where you can see the glass as you pull the bike upright. The way you tell the bike is level is where it takes the least force to hold it upright.
After you've checked it, make sure to give a little backwards pull when setting it down on the stand to make 100% certain the stand will not fold up on you.


____________
If you build something Idiot Proof, The world will build a better Idiot.

  Ignore this member   
entropy


Moderator
Posts: 8671
posted July 04, 2002 08:03 AM        
the trailer trick is good, but be careful NOT to pull the forks down too much as the level will rise in the glass giving a reading which says you have more in the bike than you really do.

Normally, I sit on the ground on the side next to the sight glass and gently tug on the r bar pulling the bike carefully upright, just to the balance point. easy does it and its safe; done it many, many times and it hasn't fallen on me yet. Make sure the bike is in gear and that the stand is fully down...

There have been several engine failures lately from APPARENTLY running with low oil. I keep mine at the 1/2 glass level now!!!


____________
This moderator uses moderation in moderation

  Ignore this member   
TripodMeat


Expert Class
Posts: 125
posted July 04, 2002 05:20 PM        
I get my wife to look at the level!!!
  Ignore this member   
ZXtra


Expert Class
Posts: 490
posted July 04, 2002 06:04 PM        
Re: Checking oil level

I check it on the stands (front and rear). I'm just a weekend rider so between rides I always get the tires off the ground. -ZXtra
____________
The sixth sick sheik's sixth sheep's sick!

  Ignore this member   
Zhooligan


Moderator
Post Whore Extraordinaire!
Posts: 3829
posted July 04, 2002 06:53 PM        
Another excuse to get the wife bent over in the garage!
____________
To those who do not count their life in years, but in how life
has touched them in the past and how much it can hold in the
future; -- Youth is forever.

  Ignore this member   
Zhooligan


Moderator
Post Whore Extraordinaire!
Posts: 3829
posted July 04, 2002 06:54 PM        
Another excuse to get the wife bent over in the garage!
____________
To those who do not count their life in years, but in how life
has touched them in the past and how much it can hold in the
future; -- Youth is forever.

  Ignore this member   
zx12rpilot


Expert Class
Posts: 120
posted July 05, 2002 01:46 AM        
I got a ZX12 for my wife. It was a great trade!
  Ignore this member   
eddynasty


Novice Class
Posts: 89
posted August 11, 2002 09:13 AM        
I use a mirror with a handle.
  Ignore this member   
BA


Pro
Posts: 1592
posted August 11, 2002 09:59 AM        
I either use the rear stand, or have someone else sit on the bike for me.

I've tried the 'calibrated piece of wood' thing, and I've tried the "just grab the right handle & brake lever and bend down while feeling for the bike's 'straight-up-edness'. Didn't like either one personally.

Even on a rear stand, you'll get an accurate reading. If you look close enough, you can see that the oil line is *slightly* higher on the right side of the glass than on the left. It's a minute difference, so ya gotta look close.


I bought a Muzzy stand with his aluminum spools. I love the set up.

Pit Bull stands are top notch, you won't find any better.


  Ignore this member   
Eddynasty


Novice Class
Posts: 89
posted August 11, 2002 11:25 AM        
As I mentioned I use my wifes hand held mirror while I sit on the bike. I'm sure pitbull is a great product but I can buy a bike jack at Sam's club for less.
  Ignore this member   
GOZR


Zone Head
GOZR
Posts: 716
posted August 11, 2002 05:35 PM        
I have a brick under the stand..perfect
  Ignore this member   
ZHooligan


Moderator
Post Whore Extraordinaire!
Posts: 3829
posted August 11, 2002 05:59 PM        
I put three quarts in when I change the oil and filter. I so this on my hoist with the front wheel clamped so the bike is vertical and level. Check the oil and note that the oil is in the middle of the window. For GP sakes I have put the bike on my pit bull rear stand so I know where three quarts is on the site glass with the bike on the stand. There isn't much of a change between on the lift or on the stand.

Other then that occasionally I will check it by holding the handle bar and standing the bike up while on a knee looking at the site glass. I have never had to add any oil between changes. I change my oil every 1500 to 2000 miles.
____________
To those who do not count their life in years, but in how life
has touched them in the past and how much it can hold in the
future; -- Youth is forever.

  Ignore this member   
Eddyirish


Parking Attendant
Posts: 19
posted August 11, 2002 06:38 PM        
ZHooligan...Pretty much my oil change intervals. I like 3 qts & a splash to bring it to the upper level of the glass..GOZR has a inexpensive solution .
  Ignore this member    Click here to send Eddyirish an AIM message. 
Eddyirish


Parking Attendant
Posts: 19
posted August 11, 2002 06:39 PM        
ZHooligan...Pretty much my oil change intervals. I like 3 qts & a splash to bring it to the upper level of the glass..GOZR has a inexpensive solution .
  Ignore this member    Click here to send Eddyirish an AIM message. 
frEEk


Administrator
ummm... yeah
Posts: 9660
posted August 11, 2002 08:39 PM        
geez, whats with all the fancy methods? i just hunch down at look at the window while holdin the bike vertical. gotta add oil bit by bit & check it every time. kinda inconvenient in a way, but given that i always give the oil time to settle before checking, it works out fine fer me.
  Ignore this member    Click here to visit frEEk's homepage. 
ZHooligan


Moderator
Post Whore Extraordinaire!
Posts: 3829
posted August 11, 2002 08:53 PM        
I forgot ot add that I always wear a white lab coat when checking my oil to insure the examination is completed correctly.
____________
To those who do not count their life in years, but in how life
has touched them in the past and how much it can hold in the
future; -- Youth is forever.

  Ignore this member   
frEEk


Administrator
ummm... yeah
Posts: 9660
posted August 11, 2002 09:54 PM        
y'all fancy pants folks wit yer garages instead a barns ahn real concrete fer yer floors. betcha youse a real funnel stead o a no name braend cola bottom top y'all cut awf wit da sheep shears. hell, ya'll prolly even youse real moter oil stead a fat from yer barbeekyoo!
  Ignore this member    Click here to visit frEEk's homepage. 
ra12r


Zone Head
Posts: 919
posted August 12, 2002 06:41 AM        
Just press the buttons in sequence on the dash face and the instrument panel will give you an oil level reading instead of the fuel level.
____________
All must bow to the "Ra Supremecy"...

  Ignore this member   
Eric00zx12r


Novice Class
Posts: 97
posted August 12, 2002 08:59 AM        
quote:
Just press the buttons in sequence on the dash face and the instrument panel will give you an oil level reading instead of the fuel level.


You want to explain this a bit further. You saying there is a oil level sensor on the bike that you can have displayed on the fuel graph. If so what is the sequence of the buttons.
____________
Eric
00ZX-12R
Candy Persimmon Red


  Ignore this member   
ra12r


Zone Head
Posts: 919
posted August 12, 2002 09:44 AM        
That was the problem with the early fuel gauges, it was reading the oil level and everyone thought is was the gas. That is why it was so easy for them to fix it at the dealership.
____________
All must bow to the "Ra Supremecy"...

  Ignore this member   
All times are America/Va [ This thread is 2 pages long: 1  2     Next» ] < Previous Thread     Next Thread >
BIKELAND > FORUMS > ZX12R ZONE.com > Thread: Checking Oil Level ?????? NEW TOPIC NEW POLL POST REPLY

FEATURED NEWS   Bikeland News RSS Feed

HEADLINES   Bikeland News RSS Feed


Copyright 2000-2026 Bikeland Media
Please refer to our terms of service for further information
0.22571802139282 seconds processing time