BA
Pro
Posts: 1592
|
posted May 29, 2004 01:31 PM
 Edited By: BA on 29 May 2004 22:40
Got Flow???
Wasn't sure if you could tell or not but they tell me this puppy has been ported!
BY THE WAY, I seem to have a circlip in the bin of engine assemply stuff from the engine assembler. It's about the size for you thumb to fit through.
Anyone have any idea where this goes on the bike, or IF it goes on the bike!
  
|
matt sterbator
Pro
Hiding in the bushes
Posts: 1367
|
posted May 29, 2004 02:00 PM
Get that little stamp on the back of the cylinder head ? 
____________
Some day, you're going to run out of some days
|
canadamaxxer
Pro
Posts: 1090
|
posted May 29, 2004 02:36 PM
The clip sounds like a wrist pin clip. I sure hope that it was a spare (that's why it's a good idea to count everything before and after surgery).
It looks like at the very least the ports have been matched.
|
TurboBlew
Moderator
BUSY DOING THE SCHIAVO
Posts: 4590
|
posted May 29, 2004 10:20 PM
Hows the exhaust side look?
____________
Official Charter Member of the RIDERS OF KAWASAKI MEMBERSHIP REVOCATION CLUB
Also a BadAss Internet Forum Moderator 4 Hire!! Come at me brah!
|
ninja12
Needs a job
Posts: 3310
|
posted May 30, 2004 05:36 AM
Edited By: ninja12 on 30 May 2004 06:37
IF that circlip is for that engine , you're in for a world of pain.
It will allow the wrist pin to destroy the cyclinder wall. If you had a 1270/1375 installed then it may be a extra from the old pistons. good luck.
|
BA
Pro
Posts: 1592
|
posted May 30, 2004 10:47 AM
thanks for the tip on the circlip possibility canadamaxxer.
luckily, if it does end up in engine failure I know that *I* won't be paying for it!!!
|
canadamaxxer
Pro
Posts: 1090
|
posted May 30, 2004 04:18 PM
Thank god for that!!! As an experienced engine builder, I can remember that sick feeling in my stomach when I thought I forgot to put something in....then felt a huge sigh of relief when I recounted and relized that I was ok.....
|
MadMike
Moderator
FEAR THE BLACK FLAG!!!!!!!!
Posts: 6579
|
posted May 31, 2004 08:09 AM
does it have the holes in the ends like a real circlip? or is it just wire?
____________
200-MPH CLUB MEMBER!
|
BA
Pro
Posts: 1592
|
posted May 31, 2004 06:36 PM
Well, I'm looking at it right now, there are not those holes in the end.
It's basically a round wire. (guess I didn't know my circlips very well, eh?) 
it just fits around my middle finger. I'm HOPING it's an old part from the tear-down.
|
|
|
HOME
NEW TOPIC