sprockets for zx12, efir zx14, frame sliders zx14 @ CLASSIFIEDS

HOME

ARTICLES

JOIN

BIKELAND > FORUMS > CLASSIFIEDS > Thread: sprockets for zx12, efir zx14, frame sliders zx14

NEW TOPIC POST REPLY

mrsantafe

Zone Head
Posts: 521

posted May 05, 2007 08:48 AM

sprockets for zx12, efir zx14, frame sliders zx14

For sale various sprockets for the zx12

1. titan tough sprocket specialties 44 tooth rear $55 shipped
2. 2 aluminum rear sprockets 47 tooth $40.00 shipped
3. stock sprockets 18-46 cheap make offer

efir for zx14 retails $334.95 from schnitz racing $175 shipped
frame sliders zx14 bolt on to the engine mounts $20 plus shipping

Ignition Retard Unit, Kawasaki ZX-14 - Schnitz
2006-2007

Ignition Retard Unit, Kawasaki ZX-14 - Schnitz
The EFIR-ZX14-06 Retard Module allows the user to progressively retard the ignition timing on the 06-07 ZX-14 with a 12 volt signal. This is a Must for Bikes with Nitrous or Turbos

The EFIR-ZX14-06 also has a timing advance feature that can be used when running the bike without nitrous. This timing advance is applied progressive between 5,000 and 6,000 RPM. Stock timing is used below this rpm to prevent detonation. By advancing the engine at higher rpm, a horsepower increase of as much as 2% can be seen.

This unit plugs right into the factory wiring harness, and is 12 volt activated. Hook it right up to your nitrous solenoids or a pressure switch on your turbo bike, and retard the timing to save your engine.

It is programmable with dipswitches from 0-16 degrees of timing retard, and also has dipswitches to adjust the built time from .250 to 4 seconds.

EFIR's are easy to wire, but you have to wire them correctly. If not wired correctly the bike won't start, or will shut off when it's activated, so read first then wire!