lazarosp
Novice Class
Posts: 67
|
posted June 24, 2012 08:04 AM
 Edited By: lazarosp on 24 Jun 2012 16:05
Greetings from Greece
Hello everyone, I am Lazaros from Greece and I own a 07' ZX14 with the following mods:
full exhaust 4 into 1 TiForce
DNA air filter
power commander III with ignition module and quick shifter
g-pack over 3
wiseco pistons
muzzys camshafts, cam sprockets and valve springs
ported head
46mm throttle bodies
higher volume fuel pump
removed counterbalancers
high volume oil pump gear
muzzys radiator fan
I never drag raced it yet but the previous owner did and made 1/4m 9,2sec.
Here are some dynos all of them on a Dynojet 200i
Happy to be here 
  
|
Wheelie
Needs a life
Old Man
Posts: 6902
|
posted June 24, 2012 08:06 AM
quote:
Hello everyone, I am Lazaros from Greece and I own a 07' ZX14 with the following mods:
full exhaust 4 into 1 TiForce
DNA air filter
power commander III with ignition module and quick shifter
g-pack over 3
wiseco pistons
muzzys camshafts, cam sprockets and valve springs
ported head
46mm throttle bodies
higher volume fuel pump
removed counterbalancers
high volume oil pump gear
muzzys radiator fan
I never drag raced it yet but the previous owner did and made 1/4m 9,2sec.
Here are some dynos all of them on a Dynojet 200i
Happy to be here
Glad to have you.
wee
|
smokinstorm
Zone Head
Old Drag Racer
Posts: 504
|
posted June 24, 2012 08:58 AM
Welcome. Good looking dyno sheet. Somebody chime in but does the A/F look a tad lean for real world riding with the ram air effect? I thought they had to be tuned a little richer to compensate for the ram air effect.
____________
2009 Monster Edition ZX14
It's all stock I swear. Well...almost.
2005 Turbo Busa
2001 GSXR 1000
Looking for a 1985 GS1150E
|
KoflaOlivieri
Expert Class
Posts: 298
|
posted June 24, 2012 09:05 AM
Welcome to the forum! Have any bike pics?
____________
Riding My Own Biography: (MotoVlog)
2010 Kawasaki ZX-14
1985 Yamaha V-Max 1200
1977 Kawasaki KZ 1000
1975 Kawasaki Z1 900
1974 Kawasaki H2 750
1972 Kawasaki H2 750
|
lazarosp
Novice Class
Posts: 67
|
posted June 24, 2012 09:59 AM
Edited By: lazarosp on 24 Jun 2012 17:59
quote:
Welcome to the forum! Have any bike pics?
|
lazarosp
Novice Class
Posts: 67
|
posted June 24, 2012 10:06 AM
quote:
Welcome. Good looking dyno sheet. Somebody chime in but does the A/F look a tad lean for real world riding with the ram air effect? I thought they had to be tuned a little richer to compensate for the ram air effect.
Well this is my biggest problem. I was going to ask you what would be the best AFR for real world riding (not on the dyno)? I am going to buy a power commander-v and the wide band 2 with the LCD-200 to make multiple maps on the street with the ram air effect and sent them to the power commander on the fly. I am so confused from what I read about the AFR, some say the best power comes with 13.5 some others say 13 and others 12.8/12.6 all these on the street. What should I do?
|
BLK ICE
Pro
we'll leave the light on for u
Posts: 1709
|
posted June 24, 2012 08:58 PM
Edited By: BLK ICE on 25 Jun 2012 04:59
Welcome, nice looking bike  , I have found 12.8 works well for my stockmotor 07 zx14.
____________
Fastest Stock Motor, Stock Bodywork, Hand Clutch, N/A Super Heavy Hitter on the Planet!
Fastest Stock Motor, Stock Bodywork, Hand Clutch, Nitrous Super Heavy Hitter on the Planet!
Bikeland 1/8 mile 5 sec.N/A Stock Motor Club Member.
Repersenting: BLACK ICE PERFORMANCE and NO QUARTER MOTORSPORTS
Nitrous and Tires Sponsored by: Custom Specialties Cycles
Dyno Tuned by: Garron of ADAMS PERFORMANCE. http://www.adamsperformance.net/
BlackIce Performance: Honor, Freedom, Love of Country!
(I am open to Sponsorship and Product Testing and Review. Contact BlackIce Performance at blackice_performance@yahoo.com) or BlackIce Perf on Facebook
|
epd345
Pro
Posts: 1494
|
posted June 24, 2012 09:58 PM
Great Pics/Bike. Welcome aboard Captain
____________
2012 ZX14, Ceramic Coated Brock's CT Meg, PCV, throttlemeister
|
lazarosp
Novice Class
Posts: 67
|
posted July 15, 2012 05:34 AM
I don't know why but for some reason my thread is double
http://www.bikeland.org/board/viewthread.php?FID=27&TID=68170&set_time=
|
lazarosp
Novice Class
Posts: 67
|
posted August 09, 2012 03:56 AM
quote:
Hello everyone, I am Lazaros from Greece and I own a 07' ZX14 with the following mods:
full exhaust 4 into 1 TiForce
DNA air filter
power commander III with ignition module and quick shifter
g-pack over 3
wiseco pistons
muzzys camshafts, cam sprockets and valve springs
ported head
46mm throttle bodies
higher volume fuel pump
removed counterbalancers
high volume oil pump gear
muzzys radiator fan
I never drag raced it yet but the previous owner did and made 1/4m 9,2sec.
Here are some dynos all of them on a Dynojet 200i
Happy to be here
Do you guys think that I will have any gains in HP if I replace my TiForce exhaust with a Muzzy M14 or a Brocks system?
|
1badzx14
Expert Class
08 Turbo zx14!!!
Posts: 133
|
posted August 09, 2012 04:44 AM
nice looking 14 !!!!!
|
pwshadow
Novice Class
Posts: 51
|
posted August 09, 2012 11:19 AM
quote:
Do you guys think that I will have any gains in HP if I replace my TiForce exhaust with a Muzzy M14 or a Brocks system?
Maybe but they wont be noticable. Especially compared to the cost. Maybe 2 horsepower at best. If you were replacing stock exhaust, that would be another story.
|
dubious
Needs a life
Needs more time to ride!
Posts: 8442
|
posted August 10, 2012 04:19 AM
Nice bike Lazaros
what part of Greece you from?
My girlfriend is from Athens.
By the way, I would not run the forks pulled up in the triple clamps so much,
You will smash the oil pan / drain plug into the ground if you come down hard from a wheelie and the forks are raised more then about 5/8 inch.
You should check to make sure the horn is not being pushed into the radiator from the fender when the suspension compresses.
____________
natural selection.....
destiny will overcome intervention.
Some are not worthy of the effort.
|
lazarosp
Novice Class
Posts: 67
|
posted August 10, 2012 04:28 AM
quote:
Nice bike Lazaros
what part of Greece you from?
My girlfriend is from Athens.
By the way, I would not run the forks pulled up in the triple clamps so much,
You will smash the oil pan / drain plug into the ground if you come down hard from a wheelie and the forks are raised more then about 5/8 inch.
You should check to make sure the horn is not being pushed into the radiator from the fender when the suspension compresses.
I am far away from Athens, I am from Grevena (small town).
I pulled down the forks half an inch after the photos.Also I have modified my oil pan and the drain plug is located at the rear side of it now. I still have clearence issues with my Tiforce exhaust and this is why I want to replace it with a Brocks or Muzzy system.
|
chuck a
Parking Attendant
Posts: 21
|
posted September 05, 2012 04:52 PM
very nice, indeed
|
FAST Z14
Expert Class
Posts: 184
|
posted September 05, 2012 10:57 PM
Welcome
____________
FOLY HUCK
|
lazarosp
Novice Class
Posts: 67
|
posted September 06, 2012 03:39 AM
new dyno numbers & pics
|
Kawifast
Expert Class
Posts: 184
|
posted September 06, 2012 02:39 PM
Great pics and great looking pipe and bike!
____________
2012 Kawasaki ZX14-R
2012 BMW S1000RR
2012 BMW K1600GT
|
cliffrandall
Zone Head
Posts: 757
|
posted September 06, 2012 03:09 PM
Great looking bike, thanks for the F/A graph - I'd love to see it with the ram-air effect at speed (IMO might be a little lean) available via the Dynojet Wideband option.........Cool race look tip #47 - loose the chain guard.
Cliff
|
lazarosp
Novice Class
Posts: 67
|
posted September 24, 2012 12:04 PM
I am now running 17-41 gearing, any change at stock wheelbase will make any good or is it gonna be a wheelie machine?
What about extensions? How long? Am I losing power because of the longer chain? I do lot of roll ons too not only drag racing.
|
smokinZX14
Needs a life
Posts: 10197
|
posted September 24, 2012 03:58 PM
Edited By: smokinZX14 on 25 Sep 2012 00:00
quote:
I am now running 17-41 gearing, any change at stock wheelbase will make any good or is it gonna be a wheelie machine?
What about extensions? How long? Am I losing power because of the longer chain? I do lot of roll ons too not only drag racing.
If all you do is roll on racing leave it stock wheel base .. 60 MPH roll from 2 gear ...Lean over the tank and grip it and rip it ..  If you go to the track gear it 17/40 maybe even 17/39 .. That will help with the wheelys and let you get WOT faster ..
____________
Smokin Performance Cycles..
Tampa Bay , FL .. Brocks Performance Dealer ..
Gen 2 ZX14R Best ET 8.43 , Best MPH 164.95
|
lazarosp
Novice Class
Posts: 67
|
posted October 19, 2012 01:33 AM
quote:
Hello everyone, I am Lazaros from Greece and I own a 07' ZX14 with the following mods:
full exhaust 4 into 1 TiForce
DNA air filter
power commander III with ignition module and quick shifter
g-pack over 3
wiseco pistons
muzzys camshafts, cam sprockets and valve springs
ported head
46mm throttle bodies
higher volume fuel pump
removed counterbalancers
high volume oil pump gear
muzzys radiator fan
I am thinking to go on a turbo kit from MR Turbo stage 1.
What do I have to change on my motor?
|
lazarosp
Novice Class
Posts: 67
|
posted December 02, 2012 11:51 PM
I just bought a new motor for my ZX14 and it is from a 2008 my last motor had many issues to continue with.
I want to upgrade this as well but without changing piston rods etc.
I now have 46mm tb TiForce full exhaust and a pc
What else do I need to be in the 200hp range streetable?
I don't want to diassemply the motor just bolt ons and cams i needed.
|
GREYHOUNDMOSES
Expert Class
Posts: 324
|
posted December 03, 2012 02:49 AM
|
vailes3705
Expert Class
Gettin Better
Posts: 235
|
posted December 03, 2012 05:38 AM
quote:
+1...Little shot of juice will get ya there. Bout to go that route myself.
____________
2011 ZX14
Best 1/8 mile to date:
5.90 @ 121
1.46 60ft
|
|
|
HOME
NEW TOPIC