tking
Novice Class
Posts: 67
|
posted March 01, 2012 08:28 AM
quote:
quote:
quote: How much does this upgrade/power increase cost?
milling the heads
bowl clean up
adjustable cam sprockets and installing them
tear down and reassemble
Milling head 60.00
bowl blending just some time
cam sprockets 50.00
springs 150.00
Head gasket 90.00
oil and filter 50.00
plugs 40.00
engine ice 40.00
tear down and reassemble just some time
If I knew you were close to me, I'd drop my bike off and have it done, if of course you wouldn't mind (and charge me of course the labor because I just don't have it in me to do it myself).
I'm in Dayton Ohio
|
08smokes

Expert Class
God is love.
Posts: 113
|
posted March 01, 2012 08:18 PM
Jim what should I degree the cams at for a .020 mill? 110 intake and 108 exhaust?
|
01smokes

Needs a job
Posts: 2243
|
posted March 01, 2012 10:06 PM
quote: Jim what should I degree the cams at for a .020 mill? 110 intake and 108 exhaust?
Your builder should know this shouldn't he??
____________
PayPal, vigilart22@yahoo.com
Email, artvgl@yahoo.com
|
tking
Novice Class
Posts: 67
|
posted March 02, 2012 03:22 AM

Almost finished project, just checking if I'm posting pics right
|
08smokes

Expert Class
God is love.
Posts: 113
|
posted March 02, 2012 07:45 AM
quote:
quote: Jim what should I degree the cams at for a .020 mill? 110 intake and 108 exhaust?
Your builder should know this shouldn't he??
Be less concerned about what i'm doing and more concerned about how you won't be losing to me consistenly for the fifth year in a row.
|
Beondwacko

Expert Class
Posts: 393
|
posted March 02, 2012 08:26 AM
quote:
quote:
quote:
quote: How much does this upgrade/power increase cost?
milling the heads
bowl clean up
adjustable cam sprockets and installing them
tear down and reassemble
Milling head 60.00
bowl blending just some time
cam sprockets 50.00
springs 150.00
Head gasket 90.00
oil and filter 50.00
plugs 40.00
engine ice 40.00
tear down and reassemble just some time
If I knew you were close to me, I'd drop my bike off and have it done, if of course you wouldn't mind (and charge me of course the labor because I just don't have it in me to do it myself).
I'm in Dayton Ohio
West Palm Beach, Florida here. A little bit too far Ohio would be.
____________
08' Atomic Silver, PCIII, Brocks pipe,BMC, -1, strapped front end
|
Y2KZX12R

Needs a job
CompetitionCNC.com
Posts: 3762
|
posted March 03, 2012 05:17 AM
quote: Jim what should I degree the cams at for a .020 mill? 110 intake and 108 exhaust?
on our ss heads I recommend 110/108. But you have to check the piston to valve clearance.
However we mill the head more than .020" With just a .020" cut you may be able to run different cam timing. 106/105 always check piston to valve clearance!!!!
____________
Y2KZX12R
CompetitionCNC.com
|
08smokes

Expert Class
God is love.
Posts: 113
|
posted March 04, 2012 04:02 PM
Awesome thank you much Jim!
|
|
|