quick6
Expert Class
Posts: 257
|
posted July 15, 2011 08:44 PM
quote:
what all is need to consistently run a 100 shot other than valve springs. Im building a 13.5 compression 14 motor and would like to run a 100 every now and then. I have a kit with a spray bar and progressive box. I planned on getting a window switch. is there anything else needed to keep the motor together. I have a dry shot kit so far.
with a set of pistons a 100 shot shouldnt be a problem. but personally i rather go with a smaller shot so i can bring it in faster and more agressive. a 100 shot is going to be hard to hold down. youre going to need a long wb. the one we were spraying so much is 74in wb.
____________
2006 zx14, fully dressed and sliding(Charlie Sheen)
  
|
01smokes
Needs a job
Posts: 2243
|
posted July 15, 2011 10:22 PM
 Edited By: 01smokes on 16 Jul 2011 06:24
quote:
quote:
what all is need to consistently run a 100 shot other than valve springs. Im building a 13.5 compression 14 motor and would like to run a 100 every now and then. I have a kit with a spray bar and progressive box. I planned on getting a window switch. is there anything else needed to keep the motor together. I have a dry shot kit so far.
with a set of pistons a 100 shot shouldnt be a problem. but personally i rather go with a smaller shot so i can bring it in faster and more agressive. a 100 shot is going to be hard to hold down. youre going to need a long wb. the one we were spraying so much is 74in wb.
Ya I'm ramping in 50% worth in 1st with a ramp time over 1.5 seconds. I'm 67" and it's still bringing the front end up good not to high but just floating the tire about 1' I'm also ramping in 2nd gear .3 seconds to not hit the tire to hard and cause it to spin.
____________
PayPal, vigilart22@yahoo.com
Email, artvgl@yahoo.com
|
Fastest 1400
Parking Attendant
Posts: 23
|
posted July 16, 2011 05:53 AM
Which Plugs are you guys using for these big 100 + shots and what Plug would you recommend for a 60 Shot?
|
06redzx14
Pro
Posts: 1022
|
posted July 16, 2011 07:14 AM
Ngk cr10e factory gapped
____________
06 alien head, no flies, PC+hub, 16/45 44 43, air shifter, dry shot
|
Fastest 1400
Parking Attendant
Posts: 23
|
posted July 16, 2011 12:54 PM
I know that the CR10E is the plug to use for a big shots of gas but would that plug be too cold a plug for a 60 shot. Wud a CR9E be better.
|
Slowninja
Expert Class
Slow-ride
Posts: 189
|
posted July 17, 2011 03:02 PM
I believe i was using a cr9e on my big motor with 120 shot
____________
06 zx14
SWB
9.24 @ 148
|
|
|
HOME
NEW TOPIC