PetriK
Parking Attendant
Posts: 30
|
posted July 27, 2011 08:10 AM
Yep, lets try to figure out the baud rate first. The 21811F1... Is surely very similiar to a kwp command so i may have all the subroutines to read kwp get local id 0x21 packages already readily implemented. The KDS may be an easier alternative based on what just was written there. If we are lucky it may be just implementing this table referred above to an existing sourcecode for testing purposes. (our source is avail on bitbucket under tag ecueditor).
My email is info@ecueditor.com
  
|
tomari
Parking Attendant
Posts: 15
|
posted July 28, 2011 05:07 AM
mailed you some info just one thing more its 81 11 F1 81 04 doing some research i found:
first byte (81) 8 is the lookup table and 1 is the command byte count
second byte (11) is the address to whom the command is going (ECU, ABS ecu etc)
third byte (F1) is the address from whom is sent (diagnostic tool)
fourth byte (81) is the command that is sent
last byte (04) is the checksum (first byte + seccond byte + third byte ........ mod 100) in hex
so if the command was 3 bytes long the command woud be:
83 11 f1 commandbyte commandbyte commandbyte checksumbyte
there can only be 12 bytes in one command including everything (tablesbytes, address bytes, commandbytes and checksumbyte)
the creator of this thread helped me a lot on this but he is lost now, he told me that he will try a kwp diagnostic tool but i have no news for about 2 months from him
|
PetriK
Parking Attendant
Posts: 30
|
posted July 28, 2011 06:43 PM
Thanks - unfortunately all the internet lines are down here due to some heavy rains and flooding - so you may need to resend after my servers are back on line.
|
tomari
Parking Attendant
Posts: 15
|
posted July 28, 2011 09:14 PM
ok! let me know
|
Aod
Parking Attendant
Posts: 1
|
posted August 06, 2011 05:07 AM
Very cool project! Have you been able to read speed from the canbus?
|
cclovestorun
Parking Attendant
Posts: 1
|
posted September 19, 2011 02:12 PM
quote:
I have the analyzer reading and logging data off of the canbus !!!
now the real work can begin :-)
Roy
I know this has been a while but I would like to know what you did to get the analyzer to see your data. I just purchased an analyzer and I am unable to get it to log any data at all.
Please help.
Thanks
|
tomari
Parking Attendant
Posts: 15
|
posted September 19, 2011 11:05 PM
what bike do you try to log? model? year?
do you try to log just guage from the guage data cable or by diag port?
|
tomari
Parking Attendant
Posts: 15
|
posted September 19, 2011 11:07 PM
stay tuned at http://www.facebook.com/ecueditorcom Kawasaki progress is reeeeaaaaaaly slow but maybe something will come up these days....
|
|
|
HOME
NEW TOPIC