exposure
Parking Attendant
Posts: 4
|
posted May 24, 2005 02:40 AM
Clutch Problems - ZX10R - Stack Height
Hey guys... I have a problem with my clutch on my 04 ZX10R. I have already replaced the clutch with Barnett fibers, steels and springs. After about 5 meetings, the clutch is slipping again. When pulling the clutch down, i noticed that the very inside hub is very grooved, as is the very inside fiber (obviously).
1. Can anyone advise of the stack height. Mine is 52.8mm now
2. Is there any problem with replacing the inside fibre with a steel, given that they run off the same hub anyway. This will also help by increasing the stack height..
There are 3 racers here in Australia that have done this successfully, but i would appreciate your input on this one.
Can anyone help me..??
____________
2004 ZX-10R
9.88 @ 148MPH
    
|
HOME
NEW TOPIC