posted April 28, 2003 01:14 PM
shiftlight have a Harlan shiftlight with three wires : red, black, anc green.
Red is said to be connected to a 12 volt source that turns on with the key.
Black ground.
Green is the tack input.
which is the best places for me to connect all these three wires?
posted April 28, 2003 01:27 PM
The tach input is a light blue wire that goes into your gauge cluster. Right up there underneath your guages is probably the easiest place to splice into that wire.
The black (ground) can splice into any ground wire. I'm lazy, so I would just run it directly to the ground on the battery.
I don't know which wire it is, but I would just splice into the 12V for the parking light for the red wire.
____________
-----------
"There are only three sports: bullfighting, motor racing, and mountaineering; the rest are just games." - Ernest Hemingway
posted April 28, 2003 01:42 PM
If I recall correctly...the harlan shiftlight wont work with the signal going into the instrument cluster...I think it has to go to the #1 coil wire.
____________
Do not taunt happy fun ball!
posted April 29, 2003 04:43 AM
underside... i glued nut to plastic {so i can remove light without nut falling or taking it back apart} and added some loctite
posted April 30, 2003 05:53 AM
i have no pipe on bike right now... so when i started it it was loud but i liked it!.. still no test .... as i drained the oil...
posted May 27, 2003 06:10 AM
In the other thread you mention you put it on the black wire on the #1 coil. Isnt that the ground?
____________
Do not taunt happy fun ball!
HOME
NEW TOPIC
posted April 28, 2003 01:14 PM
.....stop doubting ...make me skkkeerreedd!!
