dubious
Needs a life
Needs more time to ride!
Posts: 8442
|
posted March 09, 2009 12:18 AM
Stan... rear caliper hanger?
Hear anything?
am I paying you, or them?
How much and when buddy?
LMK
Thanks
Lyle
eldubois@telus.net
____________
natural selection.....
destiny will overcome intervention.
Some are not worthy of the effort.
|
Shane661
Needs a life
Posts: 11494
|
posted March 09, 2009 06:58 AM
Edited By: Shane661 on 9 Mar 2009 14:58
Are you guys going ahead with the measurements you have?
I am leaning toward modifying the one I have; I want the bike rolling next week.
|
masszx14
Pro
A mind beside itself!
Posts: 1806
|
posted March 09, 2009 07:41 AM
I sent you an email
____________
universal@mind
|
masszx14
Pro
A mind beside itself!
Posts: 1806
|
posted March 09, 2009 12:25 PM
Shane,
If you only add a spacer on the axle (on the outside of the hanger),
will the nub that locks in the axle slot have enough lenght?
You actually need around 7-8 mm or so, as the Exoticycle hanger
uses that much and I guess it's reliable.
____________
universal@mind
|
dubious
Needs a life
Needs more time to ride!
Posts: 8442
|
posted March 09, 2009 06:58 PM
Edited By: dubious on 10 Mar 2009 02:59
I think I am happy with 34.5mm total width.
28.5 + 5mm
Stan will review his measuements again, and I will get on exoticycle to spin some up this week.
Are you in Shane?
What did you come up with on the rotor side measurement?
____________
natural selection.....
destiny will overcome intervention.
Some are not worthy of the effort.
|
Shane661
Needs a life
Posts: 11494
|
posted March 09, 2009 07:23 PM
Edited By: Shane661 on 10 Mar 2009 03:36
Lyle, right now my measurements are coming up 1.5-2mm shifted towards the drive side of the wheel, as compared to yours. Meaning, I am seeing a total spacer width (all inclusive) of 51mm on the brake side. On the drive side I am looking at 18mm.
I have yet another vernier coming tomorrow and I will do one final set of measurements.
Stan, the tab is still too short.
Shane
|
|