posted February 28, 2016 10:25 AM
02 zx12 head porting
Any advice on to send a cylinder head to?
Just a clean up on the exhaust ports, valve job, fresh springs retainers and shims, and valve guides.
No fancy cnc porting just a general clean up and freshen up.
Wanting to do this upcoming winter, along with the thin cometic gasket.
Easiest thing might be just to send them the whole engine. Have the head done,, button everything up, degree the cams 105/103 and send it back to me.
Just food for thought until after this season is over.